Wireless Solar Powered Beam 2500 Sensor Kit

SKU: BB-250
Solar Powered Sensors which can be mounted up to 300 ft. apart and alert a Receiver which can be up to 1/2 mile away.

Features:

  • Up to a 1/2 mile Transmission Range between the Motion Sensors and Receiver1.
  • Ability to Mount Solar Powered Sensors up to 300ft (91.44m) Apart.2
  • Pair Up to 4 Motion Sensors to One Receiver (additional motion sensors sold separately)
  • Different Tones for Each Zone to easily distinguish which sensor was triggered (Classical, Westminster Chime, Ding Dong, Whistle)
  • Volume Control
  • Exit Delay so the receiver doesn't receive any signals for 5 minutes
  • Counter Function when the zone LED flashes for each time the sensor was triggered (up to 10 times)
  • Reminder Light when the light for the zone triggered stays on for 10 seconds after the motion sensor was triggered
  • Reminder Beep when the receiver beeps every 15 minutes after the motion sensor is triggered
  • One 12VDC Output (max of 400mA) and Four Form "C" Relays (rated for 24VDC at 3 Amp) which can be set to activate for 1 second, 10 seconds, 60 seconds or 10 minutes
  • 8 Dip Switches in the Transmitter and Receiver for Coding Purposes
  • Solar Powered Sensors with 
  • Wall Mounting Holes on the Receiver
  • Operating Range: -30°F to 110°F (-34.44°C to 43.33°C)

 

Receiver Must be Plugged into an Outlet (12VDC power adapter included). Motion Sensor is Powered by a 9-Volt Battery (not included)

 

The box includes a DCR-2500 Wireless Receiver with 12VDC Power Adapter and a DCMT-2500 Wireless Transmitter with Plate Mount, Swivel Mount and Mounting Screws. Instruction manuals for both devices.

 

1. Range will vary depending on conditions and terrain.

2. Motion detection range is approximate and depends on the conditions, amount of motion, etc.

 

Features:

  • solar powered sensors with no need to worry about batteries
  • mount sensors up to 300 ft. (91.44 m) apart
  • place the base station up to 1/2 a mile away from the sensors
  • connect up to (4) different sensors to the same base station
  • an exit delay and reminder beep on the base station
  • can connect a siren or bell to the base station to be alerted if the sensors go off (sold separately)

Note: The sensors are solar powered but the base station must be connected to an electrical outlet.